[Dome Glass] Galaxy S21 Tempered Glass Screen Protector

Galaxy S21 Tempered Glass Screen Protector

• ADVANCED SOLUTION FOR ULTRASONIC FINGERPRINT - Our liquid dispersion technology makes ultrasonic fingerprint sensor perfectly compatible with DOME GLASS. Keeps your phone sharp to your touch.

• LIQUID DISPERSION TECHNOLOGY - Our patented liquid glass evenly disperses over your entire screen, including existing minor scratches or cracks, and hardens to create an impenetrable edge to edge barrier while repairing former cracks and imperfections.

Installation is very important to enjoy our product. Please watch the video

Special Installation Notes :

Before you install
1. Remove any pre-installed screen protectors before installing
2. Remove any registered fingerprints that are on the phone
3. Increase touch sensitivity to max

During the install
1. Please make sure your surface is level
2. Place the speaker masking tape on the speaker area of the phone carefully and properly
3. Gently place the installation guide on the glass
4. Wait for the adhesive to touch the bottom of the guide circle before pulling the pin.
(Do Not let the adhesive spread below the line before pulling the pin)
5. Please wait for the adhesive to spread completely before removing the installation guide
6. 1st Cure: 15 seconds on the bottom then 15 seconds on the top
7. 2nd Cure: 1 min on the bottom then 1 min on the top.
8. Re-Register your Fingerprint. Register the same finger in multiple angles

Installation is very important to enjoy our product. Please watch the video

Special Installation Notes :

Before you install
1. Remove any pre-installed screen protectors before installing
2. Remove any registered fingerprints that are on the phone
3. Increase touch sensitivity to max

During the install
1. Please make sure your surface is level
2. Place the speaker masking tape on the speaker area of the phone carefully and properly
3. Gently place the installation guide on the glass
4. Wait for the adhesive to touch the bottom of the guide circle before pulling the pin.
(Do Not let the adhesive spread below the line before pulling the pin)
5. Please wait for the adhesive to spread completely before removing the installation guide
6. 1st Cure: 15 seconds on the bottom then 15 seconds on the top
7. 2nd Cure: 1 min on the bottom then 1 min on the top.
8. Re-Register your Fingerprint. Register the same finger in multiple angles